4
Conversion Between Operating and Rolling Modes (Portable FleetPlows™ Only)
1)
To prepare for rolling,
fasten the provided tow bar angles (P/N 41580) to the front and back of the unit in the holes provided at each wheel set
frame.
2)
Remove concrete ballasts with forklift.
3)
Using the screw jacks, lower each wheel set so the FleetPlow frame is raised approximately 2 inches off the ground.
4)
Attach suitable towing chain or strap to the hole provided on the front tow angle at the swivel wheel front end.
5)
Tow slowly to the desired location on your lot and position.
6)
To prepare for operation
, use jacks to raise each wheel set so the frame is lowered onto the ground.
7)
Place the concrete ballasts on the integrated steel pads on each side.
8) Remove the tow bar angles and store on the provided storage hooks.
Operating Procedures
for Models Equipped with Full Automation - OneTAP™
1)
Turn Selector Switch to Auto, if plow is not in full up position, press the OneTAP button to raise plow to up position.
2)
Green Blinking LED Traffic Light Indicates:
Plow assembly is in the full up position, so driver may enter the
FleetPlow. Plow is stationary.
Driver should always check that the bottom wheels of the plow assembly are above
the reflective tape strips on the columns.
3)
Driver enters FleetPlow.
Vehicle must be centered
in the drive-thru, aligned with the v-point of the plow.
4)
Blue LED Spot Light
(Always ON)
:
Driver stops when Trailer Locator Blue Beam shines on front left corner of trailer, as viewed in side-view
mirror.
5)
Driver exits the cab and taps the lit green
OneTAP
start button
, conveniently located at the Start Station.
6)
Red Blinking LED Traffic Light (
and now red OneTAP button)
Indicates
: Plow assembly is now automatically lowering to the trailer top. Do
not move vehicle.
7)
Driver waits and observes plow assembly lowering onto trailer top to confirm correct positioning of trailer with the Blue Spot Light. Plow
point will be approximately 12” onto the trailer.
8)
Green Blinking LED Traffic Light
(and now green OneTAP button)
Indicates:
Plow has stopped and is in proper position for snow clearing
operation.
9)
Driver returns to cab and drives forward,
accelerating to a speed of 8-10 MPH
, to clear the snow from the roof.
10)
Red Blinking LED Traffic Light
(and now red OneTAP button)
Indicates:
Plow assembly is rising to full up starting position for next vehicle.
Plow is in motion.
11)
Green Blinking LED Traffic Light
(and now green OneTAP button)
Indicates:
Full up sensor has detected the plow assembly, stopping its
rise. The next driver may now enter the FleetPlow.
NOTE:
A back-up pendant controller is provided for manual operation for unique circumstances or in the event there is a temporary malfunction of
the OneTAP full automation module. Use of the back-up pendant control will immediately override the automated system. The back-up manual pendant
controller is stored in the box mounted on the start station.
Summary of Contents for FleetPlow 110S Base-Mount
