6
7
17
18
19
20
Position the clear tube on the signal
cable into the notch on the bottom of the
support shaft (Figure 17).
Remove the protective cap on the signal
cable plug. Align the yellow arrow on the
signal cable plug with the yellow arrow on
the motor module receptacle (Fgure 18).
Push the signal cable plug into the motor
module receptacle. The connection is
secured when the yellow arrow on the
signal cable plug is no longer visible
(Figure 19).
Align the orange arrow on the motor
module with the orange arrow on the
support shaft. Push the motor module
up until BOTH snaps lock into place
(Figure 20).
Install the battery compartment to the back
or side wall under the countertop using the
included screws or double sided tape (not
included). Refer to figure 21. Position the
battery compartment no further than 32”
from the motor module. Route the power
cable 10” above the floor in a position so
that it will not interfere with changing refills
(Figure 22).
R
S
T
U
V
Push the battery compartment cover onto
the battery compartment base until both
the top and bottom of the cover snap into
place (Figure 23).
Note: The batteries are already loaded in the
battery compartment cover.
.
W
Install the power cable plug into the
power receptacle on the motor module
(Figure 24).
Note: To change batteries, push the key
fully into the top of the assembled battery
compartment (Figure 25) then grip the battery
compartment cover and pull it away from the
battery compartment base (Figure 26). Load
new batteries and then repeat Step 23. Use
only Alkaline D-Cell (LR20) Excell, Procell,
Energizer Max, Duracell Coppertop, or Gold
Peak replacement batteries.
X
18
21
10” minimum height from floor
Recommended to avoid interference with
cleaning equipment.
FLOOR
32” Maximum distance
Route cable to
avoid interference
while refilling.
Secure cable to
wall as required.
22
24
25
Fig. 24
26
Fig. 24
23
