Scott Safety Protege, User Manual

Page: 82 / 104

58
APPENDIX B: QUICK REFERENCE
087-0038 REV L SCOTT SAFETY
Quick Setup
This section provides a brief amount of information for a quick setup.
1
Connect cables and Shoe Pad to Protégé. Fully charge the Protégé prior to first use.
2
Install Scott Gas Monitor software (SGM) on PC.
3
Use software to customize alarm settings and write data to monitor.
4
Remove Shoe Pad and Power On the Protege. Perform a ZERO Cal, SPAN Cal,
and daily BUMP test. See
Figure 40 .
Figure 40 Connecting the Device to a PC
Alerts & Messages
This section provides a brief amount of information on alerts and messages.
•
Alarms – The device alerts you of alarm conditions through flashing LEDs, an
audible alarm, and vibration. The specific sensor will flash with a HIGH or LOW
indication on the LCD. Alarm intensity increases from a LOW to a HIGH
condition.
•
LowBattery – The battery icon flashes and activate the alarms.
•
Over-Range Conditions – Device’s sensor(s) have been exposed to +++ very high
gas concentration exceeding sensor range.
•
Pump – Displays when pump is connected to device. Icon flashes along with
activating alarms when a low flow situation occurs.
•
Sensor Failures – FAILED indicates along with the sensor type for each sensor that
fails to ZERO or SPAN calibrate.
•
Calibration Expired – Indicates device calibration is overdue. A SPAN calibration
must be performed prior to using the device.
•
Heart Beat – Blinking indicates device is actively monitoring properly maintained
sensors.
Shoe Connector