Scotsman SW 12 USPH-S, Service Manual

Page: 5 / 6

Pagina 5
Pagina 5
5 INSTALLATION
Warning! The installation should be
carried out by a qualified operator.
• Remove screws and front panel (pitc 4).
• For wall mounting be carefull while drilling fitting
holes and use anchor bolts (pitc 5).
• Locate a suitable water drain base position and
drill a hole for hose passing through (pitc 6).
• Predispose holes for the water supply pipe and
water supply cable (pitc 11).
• Connect the water supply pipe 8 mm (3/7”) to
the inlet fitting (pitc10).
The No return valve is an optional.
Install a water tap on water inlet line.
• Connect the power supply cable inside the
electrical box (pitc 9).
The supply socket must be equipped
with an efficient earth plate and it
must be sized for the load of the
appliance (see technical characteristics).
Make sure that the mains voltage
corresponds with what is specified on
the data plate.
Make sure that there is an omnipolar
switch above the socket with a
minimum contact break of 3 mm (0.12”)
protected by fuses of suitable
amperage for the absorption of the
appliance itself (see technical
characteristics and data plate).
• Open the water tap G (pitc 11) and adjust the
water flow using a screwdriver on the central
button tap (pitc 8).