Scotchman CPO-315-RFA-BL, Manual, Page: 8 / 25

Page 7
FIGURE 4
3.3 SUPPLY TABLE SET-UP
SEE FIGURE 4 BELOW.
All of the set-ups on the table must be changed each time the size of the material being processed
changes.
TO ADJUST THE TABLE:
Adjust the supply table material guides (A). The distance between the bar (A) and the table arm (B)
must be just a little larger than the thickness of the material. Failure to adjust this arm will cause the
table to feed more than one layer of the material and will cause the machine to jam.
Adjust the guide rollers (C) to the size of the material. Leave a little clearance when adjusting the guide
rollers, for variances in the material.
For square materials, there is an optional turn over devise that is used to feed the material in the same
position every time.
Three of the material arms have proximity switches on them. Your material must be loaded so that it
feeds past the first one of these switches. These switches are designed to prevent the loader from trying to
load more than one piece onto the table at a time. When one of these switches is engaged, the feed belts
will run in reverse, momentarily, to clear the jam.
A
C
B