7
STEERING WHEEL MODULE
STEERING WHEEL MODULE SETUP
The Scosche
S3-1
offers “plug and play” steering wheel control setup. No complicated
learning, programming or splicing wires is required. Setup can be completed in just
seconds! (Tool is provided by Scosche.)
1. Break off the small flat blade
adjustment driver from the
side of the steering wheel
module housing as shown in
illustration.
2. Carefully click the selector (arrow)
dial to the correct letter that
corresponds with the brand of
aftermarket stereo you are installing:
A=ALPINE, C=CLARION, J=JVC,
K=KENWOOD, P=PIONEER, S=SONY
3. Connect the steering wheel control module harness to the Main
S3-1
interface via the 10-Pin connector. (This step not shown)
4. Plug the 3.5mm connector into the “Remote” jack on the back of your
aftermarket stereo. For Kenwood, connect the Blue wire to the remote
control input wire of the radio. (This step not shown)