Page 10
Chart
Configuration
Chart
Chart
shows a live view of your ESC. With the flight battery plugged in and the ESC
connected, the user is able to see Throttle, RPM of the Motor, Voltage, Current, CPU
Temperature, MOSFET Temperature, Power, and BEC Voltage of the ESC at any time. This
can be helpful especially when troubleshooting a particular problem.
There has Chart and Table page of the logs.
12.5 Chart and Configuration
Configuration
Configuration This allow you to config the setting like temperature degree, gear
ratio and pole pairs, sound configuration, current sensitivity gain and rpm correc-
tion.
The below feature only available on Firmware V58 or higher.
5D: Enable/Disable the sound.
5E: Can be used to correct factory default calibration value for current measurement
in case of wrong measurement found.
5F: Can be used in "PID with recalculated mode" to correct maximum RPM's
detection.
It allows to set higher or lower maximum RPM's if automatic detection was not
corrent.
5G,H,I: Allow you to set the throttle range from minimum to maximum.
5J: Allow you to control the motor when there is no throttle signal input.
5H: Adjust the throttle value, Enable/Disable by 5J.
Also there will display the tooltip when you point at the blue box.
