Main Harness
If the optional factory connector kit is being used, please disregard this section of the
instructions and refer to the instructions that were supplied with the factory connector kit.
The main harness consists of two harnesses. One is labeled (HAR-1) and the second is
labeled (GEN-1). Plug in the white 4 pin connector from the (HAR-1) into the matching 4
pin connector from the (GEN-1). The (HAR-1) also has a waterproof connector that plugs
into the MCM. The wires should be connected as follows:
HAR-1
Black wire with fuse and ring terminal – To battery Positive (+).
GEN-1
Black wire – To ground (-).
Grey wire – To turn signal power wire (Left).
Grey wire – To turn signal power wire (Right).
Orange wire – To tail light wire OR any other wire that is hot (+) when ignition is ON (NOTE:
this is an input to the alarm this connection is not designed to flash the tail light).
Note: When the main harness (HAR-1) is plugged in, the siren should chirp twice and turn signals
should flash. If the siren does not chirp; check the fuse, battery power (+) and ground (-)
connections.
If the turn signal lights do not flash, make sure that the grey wires are connected to the turn signal
power (+) wires. Connecting these wires incorrectly may damage the system.
*** Turn Signal wires will pulse 12V. If your turn signals are LED based, use
caution when installing or contact Aritronix Support for assistance***
Color Codes:
Ground (-)
Tail Light
Left Turn Signal
Right Turn Signal
Honda
Green wire
Brown wire
Orange wire
Blue wire
Kawasaki
Black wire
Red wire
Green wire
Grey wire
Suzuki
Black/White Brown wire
Green or Black Grey wire
Yamaha
Black wire
Blue wire
Green wire
Brown wire
Harley Davidson
Black wire
Blue wire
Brown wire
Purple wire
Ducati
Black wire
Yellow wire
White/Black
wire
White/Green
wire
Fuse
To Battery (+)
Accessory
HAR-1 Connector
GEN-1
Black – To Ground (-)
MCM Grey – To Turn Signal
Grey – To Turn Signal
Orange – To Tail Light
5
Note: Connect the (HAR-1) harness to the MCM only after installation is completed.
If the battery is to be removed, disconnect this connector first. Reconnect only after battery
terminals are reconnected.
Using the T-tap Connectors
1) Place female T-tap connector over wire to be tapped, close and squeeze until it snaps.
2) Now slip male T-tap connector over hinged end of the female connector.
Motorcycle Wire
1)
Female T-tap
2)
Female T-tap
Male T-tap
Motorcycle
Wire
Wire from (GEN-1)
Operation Instructions
Violation Display
When the system is disarmed, the turn signals will flash to indicate that there has been an
alarm trigger. The lights will flash once to indicate that the system has been disarmed and
additional flashes indicate the following trigger has occurred:
1 flash then 1 additional flash = Shock Trigger
1 flash then 2 additional flashes = Tilt Trigger
1 flash then 3 additional flashes = Perimeter Sensor Trigger
1 flash then 5 additional flashes = Ignition Trigger
6
