MPA3
Page 2 of 11
Issue 1
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for any given
application, Scope cannot give specific advice in this manual, as each use will require independent evaluation.
Scope has, wherever possible, employed extra safeguards to monitor the system’s performance. Certain system
installations, operational requirements or budgets may, however, limit the effectiveness of these safeguards. Again, the
suitability of the system for any given application must therefore be decided by the installer and their customer, relative
to the application and risk.
Good working practice dictates that a suitable system installation log must be generated, together with a record of the
dates when the system has been manually checked, (with the aid of signal strength meters etc.) enabling the system
performance to be compared with the original installation data. For UK equipment, Scope has no control of the use and
application of the frequencies issued by OFCOM. Some equipment that is licensed may have greater protection than
other equipment which is operated on a WT Act License Exempt basis. The supply of this equipment is governed by our
standard terms and conditions of sale, which can be found on the reverse of all order acknowledgements*, proforma
invoices*, delivery notes, price lists and invoices. Alternatively, these can be provided on request.
* Faxed proforma invoices and quotations refer to “conditions available upon request”.
Licence
For the UK, this equipment is intended for use on the 433 and 458 MHz Short Range Device licence exempt radio
frequencies and programming has been restricted to these ranges.
For use in the USA, this equipment will require a licence. Consult your dealer for further advice. For further technical
rules governing the use of this equipment you should obtain the FCC Rules and Regulations, Title 47 Part 80 to end,
including parts 90 and 95 available from the US Gov Printing Office, GPO Book store, FCC Office or
www.fcc.gov/oet/info/rules/ .
The FCC ID for this equipment is
: JRNUSAPENLINK
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety practices. The
following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity
Extremes of temperature
Corrosive liquids
This equipment is designed primarily for indoor use, and is designed to be water resistant unless expressly stated
otherwise. It must not be used in classified Hazardous Areas, including areas containing explosive or flammable
vapours. If in doubt, consult your local product dealer for further information. For cleaning purposes, only use a damp
cloth, do not use alcohol or spirit based cleaning agents.
This product contains a replaceable Lithium primary (non-rechargeable) battery. Adhere to cautionary safety
information provided with or on the battery casing. Removal of covers from the equipment must only be undertaken by
authorised service personnel who must ensure that the unit is correctly sealed afterwards. Failure to do so could
undermine the units water resistance performance.
