Serially Programmable Dry Contact/Dual State Voltage Interface Unit
Page 7
A. Definitions
NORMAL STATE
This state is set for each contact to the condition that exist when the unit is powered up.
When powered up any contact that does not reflect the NORMAL STATE will be
activated.
STATE
Normally Open (Alarm when closed), Normally Closed (Alarm when open)
LOCATION
The name of the location for this event. The content must match the pager type
i.e., Numeric messages for numeric pagers.
PAGER TYPE
Select Alphanumeric, Numeric or Not Used.
BAUD RATE
The rate the paging data will be transmitted to the paging receiver. Reference the Pager
Programming Sheet accompanying your order for the correct baud rate.
PAGER ID
Enter the full Seven digits of the pager the data is to be transmitted.(i.e. 0013200)
PAGER BEEP
Alerts type A, B, C, or D.
MESSAGE
Enter the message you want displayed on the pager when the alarm is activated
REPEATS
The number you enter is how may times the paging message will be sent to the
transmitter. The time between each repeat is controlled by the period selection.
Entering the number 1 would give you an interval of approximately 18 seconds,
whereas entering 100 would give you an interval of approximately 30 minutes.
For an in-depth explanation of all functions of the DCVIP program, review the contact sensitive help
files.