Serially Programmable Dry Contact/Dual State Voltage Interface Unit
Page 2
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for any given
application, Scope cannot give specific advice in this manual, as each use will require independent evaluation.
Scope has, wherever possible, employed extra safeguards or designed optional equipment to further monitor the system’s
performance. Certain system installations, operational requirements or budgets may, however, limit the effectiveness of
these safeguards. Again, the suitability of the system for any given application must therefore be decided by the installer
and their customer, relative to the application and risk.
License
This equipment is cleared for use within the USA under a license assigned to the exclusive importer, PIPS Holdings Inc.
License No. 950415906. Certain restrictions apply in respect of power output and antenna installations.
Alternative frequencies are available by formal license application (Form 600) via the FCC. These will not be subject to
the same restrictions as the standard assigned license. You should obtain the FCC Rules and Regulations, Title 47, Part 80
to End, including Parts 90 and 95, available from the US Gov. Printing Office, GPO Bookstore, FCC Office or
www.fcc.gov/oet/info/rules/
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety practices. The
following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity or moisture
Extremes of temperature
Corrosive liquids
This equipment is designed for indoor use, unless expressly stated otherwise, and must not be used in classified
Hazardous Areas, including areas containing explosive or flammable vapors, unless express authorization has been given
in writing by the manufacturer. If in doubt, consult your local product dealer for further information.
Do not obstruct any slots or openings in the product. These are provided for ventilation to ensure reliable operation of the
product and to protect it from overheating.
Only use a damp cloth for cleaning (not liquid or aerosol based cleaners), and ensure that any power is removed from the
unit prior to beginning the cleaning operation.
Removal of covers from the equipment must only be undertaken by authorized service personnel, who must ensure that
power is isolated prior to removal.