GETTING STARTED
Please read and understand these instructions and the OPERATING
PROCEDURES section, prior to starting or riding your scooter
Assembly
1. Carefully remove the scooter from the box. Then
install the wheel ,longer spacer on the left and shorter
spacer on the right,the wheel in the middle of both
spacers,be sure to tightening screw.(FIG.1)
2. To unfold the scooter, begin by pressing
down on the FOLDING HANDLE with one
hand while gently pulling up on the handlebars
with the other(FIG.2)
(FIG.1)
3. Fully extend the handlebars to their upright
position until you feel the mechanism lock into
place(FIG.3).
4. Adjust silver clamp to the top of handle bar post .
Be sure to orient the bars in the correct riding
position with the throttle on the rider’s right
side. Secure the handlebars to the post
by tightening the bolts on the clamp with
the enclosed Allen wrench as shown. (FIG.4,FIG.5)
(FIG.2)
5. Secure the hand brakes in place by using
the provided Allen Wrench to first loosen
the tension bolts. Adjust the levers to a
comfortable position and tighten the bolts.
*BE CAREFUL NOT TO PULL ON THE
CABLES!
(FIG.3)
(FIG.4) (FIG.5)
Summary of Contents for 49cc 4 Stroke Gas Scooter
Page 14: ......
Page 18: ...Idling speed screw FIG 23 ...