Ø 7,5
Ø 7,5
Ø 7,5
Ø 7,5
25
38
72
80
Ø 7,5 mm
max.
max.
1.
2.
3.
4.
1.
2.
3.
Assembly instruction for original:
Ball bearing- and slide bearing systems
Made in Germany!
Assembly by professionals only!
Use a drilling template for competent installation. (scoop article 000133)
The door handles are maintenance-free, tested and certified.
right
left
1. Align drilling template vertically.
! Attention ! Drill holes ø 7,5 mm
from each side precisely.
Don’t drill through to avoid
damaging the mortise lock!
2. ! Attention! Follow LEFT and
RIGHT sides of bases. Press the left
base into the holes, push the handle
with spindle through the base and
the lock follower. Push the right base
over the spindles until the sup-
porting cams countersink into the
drilled holes.
! Attention! Please note that not
every door type in the lock area
is equally stable. Tighten screws
according to door type.
3. ! Attention ! The first step is to
clip on the covering rosette (follow
fixing position gap).
4. After that attach the handles,
and press them together from both
sides.
To dismantle, unlock the clamping
mechanism from below with the
enclosed tool and pull off the lever
handle. Using a rosette lifter, unclip
the covering rosettes from the bases.
Pullbloc
®
3.1
Slidebloc
®
light 3.1
scoop Beschläge Vertriebs-GmbH
Kaltenbrunn 22
D-83413 Fridolfing
E-Mail: [email protected]
Home: www.scoop-tec.de
