Unpacking your phone
This package should contain the following:
•
Telephone wall unit
•
Handset
•
Coiled handset cord
Installation
The 2554W telephone is designed for use behind a registered PBX
system. The telephone user or system installer must supply an RJ-11W
modular wall jack to connect this telephone to the PBX system. The
PBX “station port” type must be “Industry Standard Analog” or “POTS.”
This telephone cannot be used with “digital” PBX station ports.
Insert one end of the coiled handset cord into the jack on the BOTTOM
SIDE of the base unit. Insert the other end of the cord into the jack on
the bottom end of the handset.
Fit the plug on the back of the telephone into the wall jack. Align the
slotted holes on the back of the telephone over the mounting studs on
the wall jack. Pull down them on the telephone until the studs are
locked in place. Lift the handset. A dial tone should be heard in the
receiver.
Explanation of Controls
Hearing-aid Compatible Handset
VOL
switch
– Volume control switch on the handset steps through the
three available handset volume levels [Normal – Medium –
High].
Handset Jack
– Modular jack to connect coiled handset cord from
handset to telephone.
Dialing Keys
– 0 – 9 dialing keys.
Using the 2554W telephone:
To place a call:
Lift the handset, then dial the number desired.
To answer a call:
Lift the handset.
Adjusting Handset Volume
The volume control switch is located on the handset. As the switch is
moved toward top of the handset, the volume level will increase through
the volume settings of <normal – medium – high>. The volume will
decrease as the switch is moved toward the bottom of the handset.
Adjust as desired.
Summary of Contents for 2554W
Page 1: ...2554W Telephone User Guide...
