CONTACTING FACTORY
For reference and when contacting the factory, please have
your freezer information ready:
MODEL NUMBER: ________________________
SERIAL NUMBER: ________________________
DATE SHIPPED: __________________________
PURCHASED FROM: ______________________
The Model Number and Serial Number can be found on the
data plate attached to the cabinet on the back upper left
corner.
SCIENTEMP CORP.
3565 S. ADRIAN HIGHWAY
ADRIAN, MICHIGAN
49221
TELEPHONE: 517-263-6020
FAX: 517-263-5492
Sales Contacts:
Tracy Proffitt
517-263-6020 Ext. 104
Kelli Wadke
517-263-6020 Ext. 102
Web site:
1. MOVING YOUR FREEZER
The refrigeration system of the cabinet is designed to
operate with the cabinet located on a flat surface
. Do not
tilt the cabinet more than
30
to any side
. If the cabinet
must be tilted on an angle for handling or moving purposes
allow it to sit in an upright position for at least two (2) hours
prior to starting.
2. SAFETY PRECAUTIONS
In this manual, the words
WARNING
and
CAUTION
mean
the following:
*WARNING:
a potentially hazardous situation, which if not
avoided, could result in serious injury or death.
*CAUTION:
a potentially hazardous situation, which if not
avoided, may result in minor or moderate injury or damage
to equipment.
Before installing, using or maintaining this product, please
be sure to read this manual carefully. Failure to follow these
instructions may cause this product to malfunction, which
could result in injury or damage.
Below are important safety precautions that apply to this
product:
•
Use this product only in the manner described in the
product literature and in this manual. Before using it,
verify that this product is suitable for its intended use.
•
Do not modify system components.
•
The cabinet must be properly grounded in conformity
with national and local electrical codes. Never
connect the unit to overloaded power sources.
•
Disconnect the unit from all power sources before
cleaning, troubleshooting or performing other
maintenance on the cabinet.
3. CHOOSING A LOCATION
3.1
Air Circulation
The cabinet should be situated to allow proper air circulation
in a well ventilated room. Provide at least 3” of space around
the freezer for ventilation. Avoid placing the freezer in
locations exposed to direct sunlight, heat registers or any
other heat sources.
*NOTE:
The cabinet must be installed on a sturdy, solid,
level surface resting firmly on all four mou
nting points.
3.2 Ambient Temperature
Do not place cabinet in sunlight, near heating diffusers,
radiators or other sources of heat. Drafts from fans, air
conditioning or open doors can also affect the product
temperature. The ambient temperature range at the location
must be
59 to 90
F (15 to 32
C).
*Warning:
This unit is not a “rapid-freeze” device.
Freezing large quantities of liquid or high water content
items will temporarily increase the compressors to operate
for prolonged periods of time. Attempting to utilize this
freezer improperly may jeopardize safety or cause undue
stress or damage to the refrigeration compressors.
Avoid opening the door for extended periods of time since
chamber air will escape rapidly. Room air, which is higher
in humidity, will replace chamber air and may cause frost to
develop in the chamber more rapidly.
Before you get started, please take a few minutes
to read through this manual.
