ST4073
Scientech Technologies Pvt. Ltd.
8
Operating Instructions
General Information :
The logical front panel layout of
30V- 2A Power Supply
makes it easy to become
familiar with the operation of the instruments. However, even experienced users
should read the following instructions thoroughly before using the instrument.
After unpacking the instrument, check for any mechanical damage or loose parts
inside. Should there be any transportation damage, inform the supplier immediately
and do not put the instrument into operation.
Safety :
The case chassis and all measuring parts are connected to the protective earth contact
of the inlet. The mains plug shall only be inserted in a socket outlet provided with a
protective earth contact. The protective action must not be negated by the use of an
extension cord without a protective Conductor.
Warning !
Any interruption of the protective conductor inside or outside the instrument or
disconnection of the protective earth terminal is likely to make the instrument
dangerous. Intentional interruption is prohibited. The mains/line plug should be
inserted before connections are made to measuring circuits.
When removing the metal case or replacing, the instrument must be completely
disconnected from the mains supply. If any measurement or calibration procedures are
unavoidable on the opened-up instrument, these must only be carried out by qualified
personnel acquainted with the danger involved.
Operating Conditions :
The ambient temperature range during operation should be between 0°-40°C and
should not exceed - 20°C or + 70°C during transportation or storage. The operational
position should be normal however; the ventilation holes on the
30V, 2A Power
Supply
must not be obstructed. Prior to calibration a preheat run of approximately 30
minutes is required.
