Care, Maintenance and Repair
VarioProtect 3XL-W Digital TC | Version 1.02 | EN
17
13.2 Replace front pane and filter
Replacing the outer pane if it is damaged (cracked,
scratched, dirty or full of holes).
1. Unscrew the nut (A) and remove the complete frame
(B) (Fig. 9).
Fig. 9: Replacing filter and front pane
2. Gently push out the old front screen and place the new
outer front screen in the previous position (C).
Fig. 10: Replacing filter and front pane
3. Remove the welding filter from the frame (D). Place a
finger in the semi-circular hole and pull out the inner
lens (E). Place the new inner screen by inserting one
side of the protective plate into one of the two side
slots and bending the protective plate only until it sli-
des into the slot on the other side.
Fig. 11: Replacing filter and front pane
13.3 Replace the batteries
4. Gently press the battery cover until it is open (F).
Fig. 12: Battery replacement
5. Use the tool ( at the back of the battery compartment
cover) to remove the batteries (G). Insert new batte-
ries and close the battery compartment cover again.
ATTENTION!
Failure to comply with this instruction may expose
the operator to health risks and invalidate the war-
ranty.
We accept no liability if the welding helmet is used
for other purposes or these instructions are not follo-
wed.
