- 19 -
5.4
COPY
The COPY button offers you the opportunity to copy all parameters of a certain circuit or the
omplete time program and insert it into the program of one or many other control circuits.
ZONE, signal and number of
Zone 2
start to blink. „COPY“
appears in the display to signalise the copy mode. Push
COPY
to paste the data of
Zone 2
(heating area 2). The
data of
ZONE 1
are now copied into
ZONE 2
, The numeric
2
is signalling the completion of the copy process.
Now
ZONE 3
is selected and starts to blink. Push
COPY
to
paste the data of
ZONE 2
into
ZONE 3.
The numeric 2 and 3 are signalling the completion of the
copy process.
Now push the
SEL
button to select a new zone.
In the next step
ZONE 4
is selected (4 starts to blink).
Push the
COPY
button to paste the data into
ZONE 4.
The display is signalling the completion of the copy
process. The data of
ZONE 1
has now been pasted into
ZONE 2-3-4
. To finish the copying of the
parameters
you
have to press
DISP
, while you have to use the
PR
-button
to finish the copying of time programs.
To copy parameters hold
DISP
(approx. 3 sec., chapter 3.11).
Protected function!
To copy time programs use the
PR
button
(chapter. 2.2).
To exemplify the procedure, we try to copy data
of
ZONE1
.
Summary of Contents for ThermoControl Plus M2
