4BN/L6-24,4SN/L5 -24 Manual
IM100310
RD: MAR, 2010
RL: 1A - BA
21
FCC ID: PUC YCT-107
IC: 4163A-YCT107
This device complies with part 15 of the FCC Rules. Operation
is subject to the following conditions: This device may not cause harmful
interference, and this device must accept any interference received including
interference that may cause undesired operation. The manufacturer is not re-
sponsible for any radio or TV interference caused by unauthorized modifica-
tion to this equipment. Such modifications could void the user’s authority to
operate the equipment.
FCC ID: CMR-100
IC: 4163A-CMR1000
This device complies with part 15 of the FCC Rules. Operation is subject to
the following conditions: This device may not cause harmful interference, and
this device must accept any interference received including interference that
may cause undesired operation. The manufacturer is not responsible for any
radio or TV interference caused by unauthorized modification to this equip-
ment. Such modifications could void the user’s authority to operate the equip-
ment.
17. OPTIONAL REMOTE CONTROL - FEATURES AND SPECIFICATIONS
Receiver - (Model CMR-1000-24V) Kit: JP-1234-RK
Typically Factory Installed - order as optional accessory with the heater
Can be ordered as a field installed Kit; Includes: receiver, wires, Velcro Fastener, instructions
FEATURES:
· ‘House Code’ setting allows unique system “address” - avoids interference with neighbor-
ing systems
· Works with Hand Set Transmitter YCT-107
· Factory installed in heater
CONNECTION:
(Wiring Diagram: Section 14.1, Page 18)
· Connect 24V AC Line source to “ L ”
· Connect 24V AC Neutral source to “ N ”
· Connect heater 24V AC Load to “ ”
· Connect heater 24V AC Neutral Load to “ N ” (ground)
All wiring should be done by a qualified electrician. The heater, when installed, must be electri-
cally grounded in accordance with local codes or, in the absence of local codes with the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1. All wiring and elec-
trical connection must conform to the requirements of the above codes. See Section 10, page 14.
NOTE: the ON/OFF switch may be removed from the heater for secure control of the heater using
the remote control hand set only. A rubber insert is supplied with the heater to fill the hole in the
control cover where the switch was mounted.
IN IN
OUT OUT
L
N N
Hand Set Transmitter - (Model YCT-107)
JP-1234-HS
OPERATION:
4 ‘Groups’ of 4 button sets = 16 On-Off functions
House Code dial switch = 16 position - located on reverse side
Battery: 12V (type 23A) one included
SPECIFICATIONS:
Receiver
Hand Set Transmitter
Frequency 433.92 MHz
433.92 MHz
Power
12/24V +/- 10%; AC 50/60Hz.; or DC
< 26
μ
W
Max. Rating: 7 Amps
Battery: 12V (type 23A)
One Battery:
12V (type 23A)
is included with the Hand Set Transmitter.
Replace the battery in the Hand Set each year at the start of the heating season .
