27
USER MANUAL HG1000 532
8.1.2. Setting the alarm display
The standard setting for the alarm delay is 30 seconds. Within this time you can stay/move in the monitored
area without setting off an alarm.
This can be used, for example, to enter the house in quiet, without directly setting off an alarm. This alarm
delay can be set as follows:
Step 1
Step 2
Step 3
You must be in Standby Mode.
Now enter
“1-2-3-4”
or your
newly set PIN
and confirm this
with
.
If you enter the PIN correctly, the
display now shows the following
image:
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 4
Step 5
Step 6
Now press
followed by the
“7”
button, in order to get into the
settings for the alarm delay.
Now the set time delay is displayed.
(Factory settings: 30 seconds)
Press the
“7”
button as often as
you need to, until the duration you
desire is displayed.
(possible range: 10 seconds –
60 seconds)
Then confirm the set time using
. The centre now automatically
switches into the Standby Mode
again.
8.1.3. Setting the alarm duration
The standard setting for the alarm duration is 1 minute. This means that in the event that the alarm is set off,
the alarm is set off for this time and scares off any intruders through a loud alarm noise.
Step 1
Step 2
Step 3
You must be in Standby Mode.
Now enter
“1-2-3-4”
or your
newly set PIN
and confirm this
with
.
If you enter the PIN correctly, the
display now shows the following
image:
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 4
Step 5
Step 6
Now press
followed by the
“0”
button, in order to get into the
settings for the alarm delay.
Now the alarm duration that you
have set is displayed. (Factory set-
tings: 1 minute)
Press the
“0”
button as often as
you need to, until the duration you
desire is displayed.
(possible range: 1 minute –
6 minutes)
Then confirm the set time using
. The centre now automatically
switches into the Standby Mode
again.
8.1.4. Muting the countdown
If the alarm system is activated, a countdown timer sounds (as standard, this is 20 seconds, counting down-
ward). This can be muted by pressing the
MUTE
button. By pressing the
MUTE
button again the tone can be
activated again.
If the alarm system is activated in
ARM
mode, the display flashes red every 5 seconds.
8.1.5. Deactivating the system
In order to deactivate the system, either press the
DISARM
button on the remote control or deactivate the
system using the 4-digit code, followed by the
button on the central unit.
