SCHUNK VERO-S, Assembly And Operating Manual

Page: 64 / 74

Trouble shooting
64 03.00|WDP-5X |en
Trouble shooting
The quick-change system no longer clamps properly on the
change components
Possible cause Remedial measures
Clamping screw stiff Replace clamping screw (spare part scope of
delivery)
Drive hexagon socket on the clamping
screw defective Replace clamping screw (spare part scope of
delivery)
Connection point remains loose Check clamping screw for wear and replace if
necessary (spare part scope of delivery) check
that connecting shaft is installed in the correct
position
Connection point is stiff Clean connection interface and put it into
operation
Flat work surface between the modules
not achieved Clean component at the contact surfaces.
Assess sealing elements and replace if
necessary
The clamping area on the direct clamping module or
compensation module does not unlock or release
Possible cause Remedial measures
Defective air connections Check air supply ( (

5.8, Page 52) )
Defective sealing elements for air routing Replace sealing elements at the affected
change components
Pressure below minimum Check operating pressure (min. 5 bar)
A component is broken (e.g. due to
overloading) Replace the module or send it to SCHUNK for
repair
Compressed air loss in a quick-change
interface connection Tighten change interface with torque
Excess tensile load on clamping pins Reduce support weight
Clamping pins locked or clamped Be aware of the direction of rotation for
unlocking on the manual direct clamping
module or manual compensation module
9