Assembly
32
02.00|WDB 99 |en
The clamping system also has a workpiece system function, with
which the flat work surface of the workpiece or the clamping pallet
can be monitored via a differential pressure switch (see chapter
"Function of the workpiece system function"
).
For orientation of the installation position, a cylindrical pin grips
into the interface to be inserted.
WDN-M 99-70
The manual WDN-M 99-70 workpiece direct clamping module
forms the change interface to the workpiece or the clamping pal-
let. It can be positioned as the top clamping system on the WDB 99
clamping pillars via the change interface.
The drive for the clamping function of the clamping system is
manual as standard using a rotary movement on the actuator
screw which is on the side of the housing. The clamping system
can be operated by means of a hexagonal screwdriver (angled pin
wrench). The clamping force is initiated after precise torque speci-
fication using a torque wrench. No air supply is required for the
operation of the clamping system.
The clamping system also has a workpiece system function, with
which the flat work surface of the workpiece or the clamping pallet
can be monitored via a differential pressure switch (see chapter
"Function of the workpiece system function"
Mounting and connection WDN-M 99-70
5.3.6
