Maintenance and care
28
01.00|NSL mikro 50-13 1425873|en
Maintenance and care
The clamping station is designed for low-maintenance operation.
As such opening and disassembly of the clamping modules is only
necessary in exceptional cases.
CAUTION
Risk of injury and risk of damage to the pneumatic clamping
modules when opening the modules.
If a pneumatic clamping module has to be disassembled, send
the module to SCHUNK for repair.
The rear cover of the clamping module is spring preloaded and
must only be removed and installed using a special installation
tool by trained specialist personnel and in line with the
appropriate removal and installation manual.
To ensure the quick-change pallet system operates perfectly, the
following instructions must be observed:
Pressure medium: Compressed air, compressed air quality
according to ISO 8573-1:7 4 4
CAUTION
A separate maintenance unit with oiler must be used for the air
supply.
Ambient conditions and operating conditions
•
Make sure that the contact surfaces of the interface are always
clean.
•
Make absolutely sure that no chips of any kind can enter the
interface and that the interface does not fill with cooling
emulsion, which is particularly possible with vertical alignment
of the clamping pin axis. The best way to ensure neither of
these occur is to use the SDE mikro protection covers.
If the interface should fill with cooling emulsion, initiate the
unlocking process and dry out the interface in actuated state.
•
Only use high-quality cooling emulsions with anti-corrosive
additives during processing.
5
5.1
