TB2S, TB2S LH stationary power chucks
62
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
Control of types TB2, TB2 LH
An electropneumatic safety control block (24 V) is available to
actuate the front-end power lathe chuck, consisting of a pressure
control valve, pressure switch, 2 magnetic valves with automatic
clamping time monitoring including 2 sensors, and 2 evaluation
devices (see separate operating manual).
A maintenance unit, consisting of filter, water separator, and oiler,
must be connected upstream of this control block.
TB2S, TB2S LH stationary power chucks
CAUTION
No distributor ring,
no check valve,
always continuous pressure
The operating manual for the types TB2 / TB2 LH also applies
analogously for the types TB2S / TB2S LH. Due to the horizontal
chuck utilization, extra care should be taken with respect to
lubrication of the base jaws and cleaning of the fine serration.
Instead of the control unit described above, normal 5/2-way valves
are used for actuation.
9
10
