Function
02.00|1416054_ROTA-M2 + 2 |en-US
43
Fixed workpiece stops and stop jaws
The ROTA-M flex 2+2 from size 800 offers the opportunity to
realize clamping structures with one or two fixed workpiece stops
through the use of fixed workpiece stops and the related stop
jaws. Fixed workpiece stops and stop jaws are available as
accessories.
DANGER
Possible risk of fatal injury to operating personnel due to
workpiece loss when using the fixed workpiece stops during
turning operations!
The use of the fixed workpiece stops is not intended for use
under rotation.
WARNING
If fixed workpiece stops are used for clamping on the lathe
chuck, observe the maximum actuation moment permitted
depending on the clamping structure. If it is exceeded, there is a
danger of damaging the lathe chuck and a risk of injury from the
workpiece being flung out.
Observe the specified maximum actuation moment for the
clamping structure used.
Assembly of the fixed workpiece stop
1 Remove the set-screws (item 70) from the bore holes where
you want to install the fixed workpiece stop.
2 Clean the mounting surfaces of the mounting grooves at the
fixed workpiece stop and lathe chuck.
3 Place the fixed workpiece stop in the mounting grooves on the
lathe chuck and tighten the mounting screws with torque.
6.6
6.6.1
