Basic safety notes
04.00|ROTA FSW |en
7
Basic safety notes
Intended use
The product acts exclusively as an interface between the machine
spindle and clamping device in the machine tool.
• The product may only be used within the scope of its technical
• The product is intended for industrial and industry-oriented
use.
• Appropriate use of the product includes compliance with all
instructions in this manual.
The maximum speed of the design and the maximum actuating
force of the clamped clamping device must be determined by the
operator for each clamping task in accordance with the valid
standards or technical specifications of the manufacturer.
Not intended use
The product is not being used as intended if, for example,
• the clamping device is not positioned and clamped properly in
the chuck quick-change.
• the intended use of the clamping device is ignored. (See the
Assembly and Operating Manual of the respective clamping
device.)
• it is used under working environment conditions that are not
permissible.
• The technical data for use of the product specified are
• if the product is used for machines or clamping devices for
which it was not intended.
• if the product is operated without protective equipment.
Constructional changes
Implementation of structural changes
By conversions, changes, and reworking, e.g. additional threads,
holes, or safety devices can impair the functioning or safety of the
product or damage it.
• Structural changes should only be made with the written ap-
proval of SCHUNK.
2
2.1
2.2
2.3
