SCHUNK MPZ 16, Assembly And Operating Manual

Page: 37 / 52

Maintenance
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
Exchange of housing and base jaws
The base jaws and the guidance in the housing are matched. To
exchange these parts, send the product with a repair order to
SCHUNK or order the housing with the base jaws as a set.
Maintenance of version with gripping force maintenance I.D.
gripping and O.D. gripping
The pistons have to be aligned using an assembly device.
Therefore we recommend to have the module serviced and the
seals replaced by SCHUNK.
7.2 Maintenance intervals
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
•
Reduce the lubricant intervals accordingly.
Interval (million cycles)
for MPZ
Maintenance work
16 - 25 30 - 45
1.5 1.5 Treat all grease areas with
lubricant,
}
7.3 [
/
38] .
Oil or grease external steel parts.
Clean all parts thoroughly, check for
damage and wear
- 1.5 If necessary, replace
seals,
}
7.4 [
/
38] .
The seals are in the enclosed sealing
kit.
} 1.4.1 [
/
8] .
37 09.00 | MPZ | Assembly- and Operating Manual | en | 389218