Assembly and settings
36
05.00 | EGS | Assembly and Operating Manual | en | 389746
5.4 Prepare product for angle of rotation 30-135° and 215-270°
Angles of rotation of 30°–270° and various workpiece sizes can be
monitored with the sensors.
For angles of rotation of 30°–135° and 215°–270°, four switching
lugs are required. For an angle of rotation of 135°–215°, only two
switching lugs are required.
In the delivery state, an angle of rotation of 135°–215° is prepared.
Two switching lugs are on one side and two retaining plates with
spacers are fitted on the other side of the gripper finger.
In order to prepare the product for an angle of rotation of 30°–
135° or 215°–270° the two retaining places with spacers on the
side of the gripper finger must be replaced with two switching lugs
from the accessory kit.
Procedure when changing the angle of rotation of 135°–215° to
30°–135° or 215°–270°:
1. Loosen screw (1) and remove the retaining plates with the
spacers (3).
2. Mount two additional switching lugs (4) from the accessory kit
using the screws (1) on the side of the gripper finger. Insert
one small sleeve (2) with a diameter of 4 mm as a spacer
between each screw (1) and switching lug (4).
Note: The sleeve (2) is pre-assembled on the cover housing.
