Function
36
01.00|1416054_ROTA-M2 + 2 |en
Clamping the workpiece
1 Determination of the required actuation moment is based on
the clamping force calculation.
2 The workpiece is clamped by twisting the spindle (item 8) using
the actuation key or a torque wrench.
3 Check both stroke controls, which are located below the
guideways 1 and 4. Both of the indicator pins (item 19) must be
completely recessed, only then is permissible clamping
achieved.
WARNING
When a workpiece is clamped, the indicator pins must be
completely recessed. If the indicator pins are not completely
recessed, there is a risk that the lathe chuck gear will move/stay
against the stop. Risk of injury due to the workpiece being
ejected from the machine. If the indicator pin protrudes, do not
clamp the lathe chuck and do not start up.
Risk of injury due to the workpiece being ejected from the
machine.
• If the indicator pin protrudes, do not clamp the lathe chuck
and do not start up.
6.4
