_________________________________________________________________________________________
schunk.com
XND.00033.002_B – 05/2022
23
2.4
Duties of the organisation in charge
The organisation in charge of the device undertakes to only allow operatives to work on the device:
who are familiar with the basic health and safety regulations and regulations for the
prevention of accidents.
who have completed appropriate induction for working with the machine.
who have read and understood these operating instructions.
The requirements of the EC Directive 2007/30/EC on the use of work machinery must be
complied with.
2.5
Operator duties
All persons who have been instructed to work with the machine undertake to:
observe the basic regulations for health and safety and for the prevention of accidents.
read and understand the section on safety and the safety instructions in these operating
instructions prior to working with the machine, and to observe these instructions.
2.6
Operator qualification
The installation, initial setup, fault analysis and periodic monitoring have to be carried out by
competent personnel with the relevant qualifications.
2.7
Personal protective equipment
WARNING
Risk of eye injury through ejected, hot fragments!
Ejected hot fragments can lead to serious eye injury.
The regulations for safety at work and the prevention of
accidents always have to be observed when working
with the machine.
Personal protection equipment must be worn at all times,
in particular safety boots, gloves and safety goggles.
2.8
Warranty
The warranty period is 24 months from the date of delivery; the warranty applies subject to
being used as intended and to the following conditions:
Compliance with concurrent documents.
Compliance with environmental and operating conditions.
Compliance with the specified maintenance and lubrication intervals.
Observance of the maximum service life.
Any parts in contact with workpieces are not covered by the warranty.
Warranty – maximum service life
Warranty period
24 months
Maximum service life [clamping cycles]
50,000
