•
7
•
Attach the Handle
10.2
: Remove the two top screws from each side of the charger.
Align the handle so the screw holes are aligned with the screw holes on each
side of the charger. Attach the handle using the same screws you previously
removed.
CONTROL PANEL
11.
Timer
Timer Setting
•
: The timer allows you to set a specified time for charging.
After the timer expires, the charger stops charging your battery. The main
function of the timer is to prevent over charging while allowing a battery
time to obtain a satisfactory charge. To properly set the timer, you must
know the size of the battery in ampere hours or reserve capacity in minutes
and the state of charge. It is important that you determine the appropriate
state of charge of your battery as specified in Section 13 and set the timer
accordingly.
Hold
•
: This position defeats the timer function, allowing for continuous
operation.
Be sure to monitor the charging progress and stop it when the battery
◦
is charged. Not doing so may cause damage to your battery or may
cause other personal property damage or personal injury.
Ammeter
The Ammeter indicates the amount of current, measured in amps, that is being
drawn by the battery. As a battery takes on a charge, it draws less current from
the charger. Correspondingly the meter will show less current being drawn by
the battery. When the current stops decreasing, the battery is charged. The
start area of the meter indicates a high rate of current being drawn from the
charger. When cranking an engine, the meter needle will be at the extreme
right side of the start area.
