Schumacher Electric SL886RU, Owner'S Manual

Page: 3 / 47

• 3 •
4. FEATURES
1. Rotating ball joint
2. 6W COB LED
3. Micro USB charging port
(under cover)
4.
Charging status LED
5.
Power button
6. Button for opening unit
7. Micro-USB charging cable
8. Hook
9. Magnet
1
2
3
4
5
6
9
7
8
5. CHARGING
IMPORTANT! CHARGE THE WORK
LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND AT
LEAST EVERY 6 MONTHS.
Failure to do this will reduce the battery’s
capacity and may void the warranty.
5.1 Before charging, make sure the work light
is turned off.
5.2
Insert the micro USB end of the charging
cable into the micro USB port on the back
of the work light.
5.3 Insert the USB end of the cable into the
USB port on your charger.
5.4 Plug your charger into a live power
source.
5.5 The red charging status LED will blink, to
indicate charging has begun.
5.6
Charging will take approximately 4 hours.
Do not charge the work light for more than
24 hours.
5.7 When the battery is fully charged, the LED
will change to green.
5.8
Unplug the unit from your charger.
5.9 Recharge the work light after use, and at
least every 6 months.
6. OPERATING INSTRUCTIONS
USING THE WORK LIGHT
IMPORTANT: Charge the internal battery
before use. (Make sure the work light is
powered off before charging.)
6.1 Hang the work light, using the hook on
the bottom. Press the button on the front,
to open and rotate the work light for more
precise positioning.
6.2 The magnet may be used instead. Attach
the magnetic end of the work light to any
ferrous metal surface.
6.3 Direct the lens away from your eyes
before turning the light on.
6.4 Press the Power Level button on the
back of the unit for low power.
6.5 Press the Power Level button again for
high power.
6.6 When finished using the light, press the
Powel Level button, to turn the unit off.
6.7 Recharge the work light after use, and at
least every 6 months.