•
12
•
MAINTENANCE INSTRUCTIONS
13.
After use and before performing maintenance, unplug and disconnect the battery
13.1
charger (see sections 6, 7 and 8).
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
13.2
cords, and the charger case.
Ensure that all of the charger components are in place and in good working condition,
13.3
for example, the plastic boots on the battery clips.
Servicing does not require opening the unit, as there are no user-serviceable parts.
13.4
All other servicing should be performed by qualified service personnel.
13.5
MOVING AND STORAGE INSTRUCTIONS
14.
Store the charger unplugged, in an upright position. The cord will still conduct electricity
14.1
until it is unplugged from the outlet.
Store inside, in a cool, dry place (unless you’re using an on-board Marine Charger).
14.2
Do not store the clips on the handle, clipped together, on or around metal, or clipped to
14.3
cables.
If the charger is moved around the shop or transported to another location, take care to
14.4
avoid/prevent damage to the cords, clips and charger. Failure to do so could result in
personal injury or property damage.
TROUBLESHOOTING
15.
PROBLEM
POSSIBLE CAUSE
REASON/SOLUTION
No reading on the ammeter.
Charger is not plugged in.
No power at the receptacle.
Clips are not making a good
connection to the battery.
Connections are reversed.
Battery is defective (will not
accept a charge).
2 or 4 amp charge rate is
being used.
Plug the charger into an A.C.
outlet.
Check for open fuse or circuit
breaker supplying A.C. outlet.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for
a better connection.
Unplug the charger and
reverse the clips.
Have battery checked.
Ammeter may show no
activity at the 2A or 4A charge
rate.
Ammeter reading stays high. Battery is severely
discharged.
Wrong battery voltage.
Continue charging battery for
two more hours. If problem
continues have the battery
checked.
Verify the voltage settings or
output ratings on the charger
are correct.
