•
6
•
ASSEMBLY INSTRUCTIONS
9.
It is important to fully assemble your charger before use. Remove all cord wraps
9.1
and uncoil the cables prior to using the battery charger. Follow these instructions for
assembly.
PARTS
TOOLS NEEDED
(2) 10-32, thread cutting screws
(4) ¼-20, thread cutting screws
(4) Phillips head sheet metal screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
3/8” wrench (for mounting foot)
5/16” wrench (for mounting wheels)
1/4” wrench (for mounting handle)
hammer
screwdriver (flat blade)
screwdriver (Phillips)
Attach the Foot:
Remove the charger from the packing materials
and place upside down on a flat surface. Attach the foot and secure
it with the four ¼-20 thread cutting screws provided.
Assemble the Wheels and Axle
: Hold the axle
upright on the floor or work surface. Then, using a
hammer, tap one of the axle caps onto the top end
of the axle. Be sure to tap the axle cap on straight.
Slide both wheels onto the axle with the recessed
hubs facing out as shown. Install the second axle
cap.
Mount the Axle to the Charger
: Place
one end of each bracket into the slot
on the bottom of the charger. Place
the axle assembly under each bracket.
Attach the brackets using the two, 10-32
thread cutting screws provided.
NOTE:
Be careful not to drop the
brackets inside of the charger case.
