• 9 •
DESULFATION MODE
Desulfation could take 8 to 10 hours. If desulfation fails, charging will abort. The
BAD BATTERY
(red) LED will light and the yellow/orange
(CHARGING)
LED will flash.
COMPLETION OF CHARGE
Charge completion is indicated by the green
(CHARGED) LED. When
pulsing, the charger has switched to the maintain mode of operation.
MAINTAIN MODE (FLOAT-MODE MONITORING)
When the green
(CHARGED) LED is pulsing, the charger has started maintain
mode. In this mode, the charger keeps the battery fully charged by delivering a small
current when necessary. If the charger has to provide its maximum maintain current for
a continuous 12 hour period, it will go into abort mode (see Aborted Charge section).
This is usually caused by a drain on the battery or the battery could be bad. Make sure
there are no loads on the battery. If there are, remove them. If there are none, have the
battery checked or replaced.
MAINTAINING A BATTERY
The SC1272 maintains both 6 and 12 volt batteries, keeping them at full charge.
NOTE: The maintain mode technology allows you to safely charge and maintain a
healthy battery for extended periods of time. However, problems with the battery,
electrical problems in the vehicle, improper connections or other unanticipated
conditions could cause excessive current draws. As such, occasionally monitoring
your battery and the charging process is recommended.
13. MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working properly for years.
•
Clean the clamps each time you are finished charging. Wipe off any battery fluid that
may have come in contact with the clamps, to prevent corrosion.
•
Occasionally cleaning the case of the charger with a soft cloth will keep the finish
shiny and help prevent corrosion.
•
Coil the input and output cords neatly when storing the charger. This will help
prevent accidental damage to the cords and charger.
•
Store the charger unplugged from the AC power outlet, in an upright position.
•
Store inside, in a cool, dry place. Do not store the clamps on the handle, clipped
together, on or around metal, or clipped to the cables.
