• 8 •
USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the three (3) output cable leads to the charger.
WARNING:
Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1.
Connect the end of the charger output cable to the end of the battery
cable, quick-connect and clamps.
2.
Follow the steps in sections CHARGING A BATTERY IN THE VEHICLE
and CHARGING A BATTERY OUTSIDE OF THE VEHICLE to connect
the output clamps to the battery.
3.
Connect the charger to an electrical power outlet.
RING CONNECTOR QUICK-CONNECT
1.
To permanently attach to a battery, loosen and remove each nut from the
bolt at the battery terminal.
2.
Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3.
Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4.
Replace and tighten the nuts to secure.
5.
Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6.
Connect the charger to an electrical power outlet.
12V ACCESSORY PLUG QUICK-CONNECT
1.
Connect the end of the 12V accessory plug to the charger.
2.
Insert the 12V accessory plug into the 12V accessory outlet.
3.
Route the power cord from the charger through the vehicle’s open window.
4.
Connect the charger to an electrical power outlet.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the maintain
mode (see below) automatically after the battery is charged.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger’s output is shut off and the CHARGING
(yellow/
orange) LED will flash. To reset after an aborted charge, unplug the charger
from the AC outlet, wait a few moments and plug it back in.
Summary of Contents for SC-200A-CA
Page 2: ......
