Schulz Speyer Concertina, Assembly Manual

Page: 21 / 24

21
Exit 1 Exit 2
Assembly guide
Assembly guide for Concertina
Initialisation of the parallel system:
The Desk Power System is initialized by pressing the down key once or twice and holing it down until
the actuator runs into end stop.
It will then automatically run approx. 5 mm out again hereafter slowly running in again. Only
release the down key when the movement has completely stopped.
If the key is released before the sequence is complete, then the initialization is interrupted and must
be started again from the beginning. It is sometimes necessary to press the down key twice to start
the initialization, this is because the system can be in different modes when the initialization starts. If
the actuators are still not moving, then it is necessary to switch off all power from the control box for
at least 10 seconds before reconnecting the power.
If an error situation occurs at the end stop positions then CBD4 has to be reset by pressing the up
and down keys simultaneously for a min. of 5 seconds, after which a new initialization sequence can
be run.
It is very important to use the correct exit points on the control box. If 2 actuators are connected then
use exit points 1 and 2. If 3 actuators are connected, then use exit points 1, 2 and 3. If you use exit
points 1 and 4, the control box will not function.
Change of defect motor
If the customer is facing problems with the adjustability of the electrically adjustable desk the motor
itself is to be changed
- not the whole frame.
The motors are ordered at BCI’s Customer Service which arranges packing and dispatch. The defect
motors are returned to our factory for examination and repair.