Schulthess Spirit TopLine TA 6257, Manual, Page: 56 / 60

Maintenance/Care/Cleaning
Cleaning the machine
Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water.
Do not use solvents! These substances can damage
parts of the machine, produce poisonous vapour and
carry the risk of explosion!
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-ab -
ra sive cleaning product.
Cleaning the filter
When fabrics are used, the fibres are rubbed (laundry
fluff), which are released when the fabrics are dried,
collecting in the filter on the inside of the door.
The fluff filter must therefore be cleaned after every
use.
1. Press the door open button.
2. Pull out filter and open it.
3. Rub your hand over the filter and remove the fluff. It
may happen that a supposedly proper cleaned filter
becomes impermeable, due to a fine, invisible coat
remaining in the filter meshes. Hold the filter with one
flat surface up wards and pour a little water on to it. If it
is impermeable, clean the filter with a ibrush under run-
ning water.
3.1 From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so,
use a vacuum cleaner or a cleaning brush.
3.2 Run the pipe of the vacuum cleaner or the brush
around the opening for the fluff filter. Remove any resi-
dual fluff.
4. Replace the filter properly.
5. Close the door.
Cleaning the moisture sensor
After longer operation, small deposits (lime, fabric refi-
ner) can form on the front inner side of the drum on
both sides of the longish moisture sensors.
With moisture controlled programmes, this can result
in the desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.
56