11
EN
Expansion wall plugs are provided to secure the hood
to most types of walls/ceilings. However, a qualified
technician must verify suitability of the materials in
accordance with the type of wall/ceiling. The
wall/ceiling must be strong enough to take the weight
of the hood. Do not tile, grout or silicone this appliance
to the wall. Surface mounting only.
1. Using a pencil, draw a line on the wall, extending
up to the ceiling, to mark the centre. This will
facilitate installation.
2. Rest the drilling template against the wall: the
vertical centre line printed on the drilling template
must correspond to the centre line drawn on the
wall, and the bottom edge of the drilling template
must correspond to the bottom edge of the hood.
3. Place the lower support bracket on the perforation
diagram making it coincide with the traced triangle,
mark the two external holes and perforate. Remove
the perforation diagram, insert two wall-dowels and
fix the support bracket of the hood with two 5x45
mm screws.
4. Hang the hood onto the lower bracket.
5. Adjust the distance of the hood from the wall.
6. Adjust the horizontal position of the hood.
7. Using a pencil mark the cooker hood permanent
drill hole inside the suction group.
8. Remove the hood from the lower bracket.
9. Drill at the point marked (Ø8mm).
10. Insert 1 wall screw anchor.
11.
Apply the flues support bracket G to the wall
adherent to the ceiling, use the flues support
bracket as a perforation diagram (if present, the
small slot on the support must coincide with the
line drawn previously on the wall) and mark two
holes with a pencil. Make the holes (Ø8mm), and
insert 2 dowels.
12. Fix the chimney support bracket to the wall using
two 5x45mm screws.
13. Hook the hood onto the bottom bracket.
14. Fix the hood into its final position on the wall
(ABSOLUTELY ESSENTIAL).
15.
Connect a pipe (pipe and pipe clamps not
provided, to be purchased separately) for
discharge of fumes to the connection ring located
over the suction motor unit.
If the hood is to be used in ducting version, the
other end of the pipe must be connected to a
device expelling the fumes to the outside. If the
hood is to be used in filter version, then fix the
deflector F to the chimney support bracket G and
connect the other extremity of the pipe to the
connection ring placed on the deflector F.
16. Connect the electricity.
17. Apply the chimney stacks and fasten them at the
top to the chimney support G (17b) using 2 screws
(17a)
18.Slide the bottom section of the chimney down until it
completely covers the suction unit and slots into the
housing provided on top of the hood.
Remount the carbon filter frame and the fat/s filter/s
and check the perfect functioning of the hood.
Downloaded from www.vandenborre.be
