GB
15
Installation
Diagram 1
This appliance is designed to be installed in a cabinet
or other supporting structure.
Make a hole in the bottom of the wall-hung cabinet,
using the dimensions shown in diagram 1.
To fix the hood, proceed as follows:
a) Remove fat filter/s A and frame B if it is already
mounted, releasing spring C (Diagram 1).
b) Fit the hood into the opening.
c) Insert the screws supplied into the”F” holes and
tighten them to fasten
the hood to the cabinet (Diagram 1).
d) Remount the frame.
e) Reinstall the filter or grease filters.
The horizontal sections of the pipe must be slanted
slightly upwards (about 10%) to ensure an easy flow of
the air outwards.
For better efficiency, it is advisable to install the hood
slightly inwards from the cupboard edge so as to
create a recess.
The hood performs best when short pipes (max. 4 m)
with few elbows are used. Caution: do not tighten the
clamp too far, as this may prevent the check valve (V)
from operating properly.
imp. CAPPA GFE631 GFI -632-641 9-03-2007 18:40 Pagina 15
