Page 6
OPTIONAL KINO-LINEAR
™
MOUNTING PLATE
Illustration #14 - Projection Mounting Plate
1. This plate (#54-018714) replaces the
Chief MFG Pan 2 Panamorph Lens Support
and the Schneider Optics Kino-Linear / Pan
2 Bracket (#54-018713).
2. Attach the projector plate to the special
mounting holes (two places) on the projector.
The 90-degree lip should be pointing up
towards the ceiling . This plate is pre-drilled
to fit the following projectors: Sony VPL-
VW50, JVC DLA-HD10K, Panasonic PTAE-
10900U, and JVC DLA-RS1.
The plate can be drilled by the integrator to
fit additional projectors.
3. The locking “T-Nuts” should be oriented
forward to align with the slot on the rear
USE WITH JVC DLA-RS1&2 PROJECTORS
When using the Schneider Optics Kino-
Linear™ with the JVC DLA-RS1 or RS2
projectors, the standard bolts in the projector
feet may not be tall enough to avoid contact
between the Kino-Linear™ motor cover and
the surface.
To prevent any potential damage from this
contact, we recommend that you use the 50mm
replacement bolts provided with your mounting
plate to increase the clearance space.
Illustration #15 - Contact Problem with JVC DLA-RS1&2 Projectors
of the Kino-Linear™ lens mechanism. The
knurled gripping edge of the nuts should face
rearward. See
Illustration 14.
4. The lens on the Kino-Linear™ will be in
the home position when power is supplied to
unit. Position the Kino-Linear™ in front of
the projector lens and align the “T-Nuts” on
the mounting plate with the slot on the Kino-
Linear™. Slide the Kino-Linear™ sideways
until the Schneider anamorphic lens is directly
in front of the projector lens. Tighten the “T-
Nuts” until the entire assembly is secure. See
Illustration #10
.
5. If attaching a JVC DLA-RS1 or RS2 projector,
please refer to the supplemental instructions
below regarding the projector feet.
Summary of Contents for Kino-Linear
Page 1: ...KINO LINEAR USER MANUAL ...
