II/ 10
KLG / KNG / SNG
GB
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
C Staples / Nails are
not fully inserted,
bend or protrude
Tappet worn or broken
X
Contact Schneider Druckluft
GmbH or an authorised ser-
vice partner.
****
Working pressure (flow pressure)
too low
X
Increase working pressure
(flow pressure) Observe
maximum working pres-
sure
*
Compressor output too small
X
Use different output
rating
*
Hose diameter too small
X
Use correct hose diameter
*
D Device repeatedly
misfires
Piston sluggish because lubrication
insufficient
X
Lubricate device well via
plug nipple (item 01)
***
Working pressure (flow pressure)
too low
X
Increase working pressure
(flow pressure) Observe
maximum working pres-
sure
*
O-ring damaged
X
Contact Schneider Druckluft
GmbH or an authorised ser-
vice partner.
****
Hose diameter too small
X
Use correct hose diameter
*
E
Staples / Nails
jammed in the
guide plate
Magazine (item 04) dirty
X
Clean magazine
(blow out)
****
Staple / Nail strip jammed and/or
not pushed all the way forwards
X
Incorrect staples / nails
used. Insert the correct sta-
ples / nails
*
Tappet worn
X
Contact Schneider Druckluft
GmbH or an authorised ser-
vice partner.
****
F
No staples / nails
are transported
No staples / nails in the magazine
X
Insert the correct staples /
nails
****
Tappet does not retract
X
Increase working pressure
(flow pressure) Observe
maximum working pres-
sure
*
or contact Schneider Druck-
luft GmbH or an authorised
service partner.
****
Staple / Nail slider faulty
X
Contact Schneider Druckluft
GmbH or an authorised ser-
vice partner.
****
Magazine spring faulty
X
Change magazine spring or
Contact Schneider Druckluft
GmbH or an authorised ser-
vice partner.
****
Problem
Cause
Remedy
