3 Assembly and start-up
14
SCHMIDT
®
TorquePress 520-560
– V2.1
If the reference run is started in a position ≥ the value under point 3 "Max.
stroke during reference run from home position", the stroke is ended 0,5 mm
above the parameterized TDC position.
Figure 7: Restrictions of the working stroke (example)
Press
520
560
1
Ram extension at home pos.
(top working pos.)
[mm]
60
60
2
Max. negative stroke
[mm]
-27
-38,5
3
Max. stroke during ref. run from home
position *
[mm]
22
8,8
* If the reference run is not started from the home position but lower, the ram moves in negative
direction.
Adjusting the working stroke
The individual parameters of the working stroke are defined in the control
unit.
For further information, refer to the "Instructions for Use - SCHMIDT Manual
workstation"
respectively
the
"Assembly
Instructions
-
SCHMIDT
Components for automation".
3.6 Connecting the press
DANGER
Injuries or death caused by touching live parts
When carrying out assembly and maintenance work, you may come into
contact with parts that carry dangerous voltage during operation. Touching
live parts may cause death.
Any work on the electrical system or equipment must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
All connections of the press are labeled.
Observe the enclosed circuit diagram.
Press
