Varitrak
T.G. Schmeiser Co., Inc.
Ph. (559) 268-8128
Fax (559) 268-3279
25
Before Each Use
Ensure that all fasteners are tight, and all pins are secured
in place.
Inspect the frame for structural fractures.
Make sure all warning decals are in place and legible.
Inspect all hydraulic hoses and fittings for leaks or signs of
wear.
Check bucket blades for wear and damage. Replace if
necessary.
Lubricate zerk fittings on hinge plates and turnbuckles with a
good general purpose grease.
Every 50 Hours or Weekly
Perform the Daily Maintenance schedule.
Lubricate zerk fittings on hinge plates and turnbuckles
with a good general purpose grease.
Check tire pressure and set to tire manufacturer’s
recommended specifications. Inspect the tires for wear and/
or damage. Make sure the wheel lugs are tightened to the
proper torque. Refer to “Tire and Lug Torque Specifications”
on page 13.
Every 1000 Hours or Annually
Perform the Daily Maintenance schedule.
Perform the Weekly Maintenance schedule.
Lubricate zerk fittings on the transport wheel bearing hubs
with a good quality wheel bearing grease. Fill each cavity just
until resistance is felt. Do not force grease past the seals.
Remove debris and clean the entire implement with
compressed air or a pressure washer.
Remove rust and apply a coat of paint to frame surfaces
where the paint has been worn off or damaged.
Maintenance Schedule
The period recommended is based on normal operating
conditions. Severe or unusual conditions may require
more frequent service.
Copy this page to continue the record.
Hours and
Serviced By
Maintenance