Varitrak
T.G. Schmeiser Co., Inc.
Ph. (559) 268-8128
Fax (559) 268-3279
10
Tractor Requirements
Highway and Transport Operations
Make sure the wheel lift cylinder transport locks are
installed, and the jack stand is in its storage position
before transporting the unit .
Be observant of bridge load restrictions . Do not cross
bridges rated lower than the gross weight at which you
are operating .
Be a safe and courteous driver . Always yield to
oncoming traffic in all situations, including narrow
bridges, intersections, etc . Plan your route to avoid
heavy traffic.
Some localities prohibit the use of flashing amber
lights . Local laws should be checked for all highway
lighting and marking requirements .
When towing the unit on public roads, use
flashing amber warning lights and a slow moving
vehicle (SMV) identification emblem.
Make sure the SMV placard is clearly visible to vehicles
approaching from the rear .
When transporting the implement on public
roads, use approved accessory lighting, flags, or
other necessary warning devices to protect
operators of other vehicles on the highway
during daytime and nighttime transport . Various safety
lights and devices are available from your dealer .
Do not exceed a towing speed of more than
20 mph (32 KPH) on a public roadway .
Tires supplied by the manufacturer are designed to
operate NO MORE THAN 20 mph . Do not exceed the
maximum speed or tire failure may occur .
SAFETY INSTRUCTIONS
When transporting the implement on rough or uneven
surfaces, drive slowly to prevent bouncing and loss of
contact of the front wheels and the ground .
OPERATION SAFETY
WARNING
Crush Hazard (Rolling Over)
Do not clean, lubricate, or make adjustments
while the unit is moving .
Never allow inexperienced or untrained
personnel to operate the implement or tractor
without supervision .
Enter And Exit Tractor
To avoid being run over, do not enter or exit
tractor when it is moving . Avoid serious
injury or death, from contact with rotating tires, by
entering or exiting tractor only when it is completely
stopped .
Safe Distance
Keep all bystanders, especially children,
away from the tractor and implement during
operation .
Overturn Hazard
Pick the most level route possible when
transporting across fields. Avoid the edges of
ditches, gullies, or steep hillsides .
Be especially careful when turning on slopes with
the wheels down . Never turn uphill with the wheels
down except at slow speed and a low rate of turn .
Never transport or operate this machine on steep
slopes .
Periodically clear the unit of brush, twigs, or other
materials to prevent buildup of dry, combustible
materials .
Visually check all fasteners for tightness
or damage before and after operation .
Repair immediately if required .
SAFETY INSTRUCTIONS
Tractor Owner/Operator Manual
Always refer to the tractor Operator’s Manual
to ensure compatibility and maximum safety .
Be familiar with the location, settings, and function of
the tractor controls before using this equipment .
WARNING
SAFETY INSTRUCTIONS
Do not use a tractor of more than the recommended HP
to prevent damaging implement components.