Schmalz JumboPicker-Flex, Operating And Maintenance Instructions Manual

Page: 26 / 71

26 | EN www.schmalz.com 30.30.01.01183/00
5 Installation
Please read section 1.6 (Requirements & instructions for installation,
maintenance and operating staff) before starting installation.
5.1 Tool List

1 of each combination wrench SW10, 2x SW13, 2x SW19, SW46

1 pin + hex wrench set

1 of each hexagonal socket wrench insert SW5, SW10, SW13, SW19

1x socket wrench extension

1x torque wrench

1 of each Torx screwdriver T10, T25

1x flat screwdriver

1x carpet cutter

1x wire cutter

1x bolt cutter

1x spirit level

1x soft-head hammer

1x cable stripper

1x crimping pliers
5.2 Tightening Torques
Unless otherwise specified, the following tightening torques apply for assembly:
M5 M6 M8 M12
Standard screws 6 Nm 11 Nm 27 Nm 86 Nm
5.3 Mounting on the Industrial truck
5.3.1 Basic Notes
The manufacturer of the final unit is responsible for mechanically and electrically
connecting the system to the industrial truck.
The industrial truck's control unit must fulfill the signal release functions defined on
the specification sheet.
The JumboPicker-Flex's operating voltage must be equal to the industrial truck's
supply voltage.