Product description
EN-US · 30.30.01.01963 · 00 · 05/19
11 / 52
3.1.2 Depositing the Workpiece/Part (Blowing Off)
In blow off mode, the vacuum circuit of the ejector is supplied with compressed air. This ensures that the
vacuum drops quickly, depositing the workpiece quickly as well.
During blow off, [
-FF
] is shown on the display.
The ejector provides two blow off modes for selection:
•
Externally controlled blow off
•
Internally time-controlled blow off
•
Optional: external blow off
3.2 Operating Modes
If the ejector is connected to the supply voltage, it is ready for operation. This is the normal operating
mode, in which the ejector is operated by the system controller.
The ejector is parameterized using the provided menus.
“Manual operation” mode can be selected during the setup process.
3.3 Ejector Designation
The breakdown of the item designation (e.g. SCPMc 10 S04 NC M8-6 PNP BLT) is as follows:
Feature
Variants
Type
SCPM
Version
Basic: b
Controlled: c
Intelligent: i
Nozzle size
0.3, 0.5, 0.7 and 1.0 mm and EV for External Vacuum
Fluid connector
S01 (push-in, 4/2 2x)
G01 (M5 female 2x)
S04 (push-in, 6/4 2x)
G06 (M7 female 2x)
S07 (push-in, 4/2 3x)
G07 (M5 female 3x)
S08 (push-in, 6/4 2x, 4/2)
G08 (M7 female 2x, M5 female)
S09 (push-in, 4/2, 6/4 2x)
G09 (M5 female, M7 female 2x)
Suction valve control
NO (normally open), sucks when no voltage is applied
NC (normally closed), does not suck when no voltage is applied
Electrical connector
M8 plug, 6-pole
JST plug, 5-pole
Switch function
PNP (switches to plus)
NPN (switches to minus)
Individual configuration
code
The 3-digit code “AAA” uniquely describes an ejector disk.
