EN
4
© Schletter GmbH
•
Gewerbegebiet an der B15
•
Alustraße 1
•
83527 Kirchdorf/Haag i. OB
•
Germany
•
Tel.: +49 8072 9191-200
Fax: +49 8072 9191-9200
•
E-mail: [email protected]
•
www.schletter.eu
•
Updated 11/2012
•
Subject to change without notice
Your contact in the UK: Schletter UK Limited, Tel.: +44 1296 461 800, Fax: +44 1296 461 801, E-mail: [email protected]
CompactDirect Mounting Instruction
Mount module-bearing profile
•
Feed square-head screws M10x25
into lower groove of the module
bearing profile and into holes of the
supports.
•
Secure with flange nuts M10.
The upper hole is used only in a linear
arrangement. Please observe data in
the calculation documentation.
Module mounting
•
Position fi rst module to end of the profi le
•
Fasten module with two end clamps -
in our example: click in the Rapid end
clamps and tighten screws (6-Lobe T40)
•
Position further modules and secure
each by placing two middle clamps
respectively between two modules.
•
Secure last module of a row with
two end clamps.
Further information relating to mount-
ing of fasteners can be taken from the
type-specific mounting instructions.
Extend module-bearing profile
•
Position next profi le.
•
Mount connector E from below.
•
Tighten the pre-assembled screws.
Please ensure that sufficient space is
left at profile joints for the connector.
© Schletter GmbH, 2012, I400250GB, V1
For further information relating to our systems, please refer to our website:
www.schletter.eu
under Downloads in the Solar section.
