8
REPLACING THE KEYPAD BATTERIES
1. Remove the lock from the door.
2. Open the battery compartment and
replace the 9V battery.
3. Replace the lock
on the door.
PROBLEM
SOUNDS*
LIGHTS
SOLUTION
INSIDE
Alarm sounds too frequently
or false alarm
Alarm
—
Sensitivity level is too high (at 1 or 2) and should
be adjusted to a less sensitive level (3, 4 or 5). See
Sensitivity Level
on page 7.
Outside lights on inside
Schlage button are blinking
—
Left and
Right
Batteries are low and should be replaced. See
Replacing
the Alarm Batteries
on page 9.
The tamper alert is not
sounding.
—
—
There is a 60-second delay before device alarms to allow
you to exit and lock the door.
OUTSIDE (KEYPAD)
I forgot my Programming Code.
Check front of Keypad Locks Programming Guide or back
of keypad assembly for default Programming Code.
If needed, restore lock to factory settings.
Terms You
Should Know on page 5
I need to delete a User Code that I don’t remember.
Delete all User Codes. Then add all needed User Codes
back into the lock. See the
Keypad Locks Programming
Guide
.
User code does not unlock
lock.
2
Red
User Code entered is not a valid User Code.
1 High,
1 Low
Green
then Red
Vacation Mode is enabled. See the
Keypad Locks
Programming Guide
to disable Vacation Mode.
does not light when numbers are pressed.
Too many incorrect User Codes have been entered. Wait
30 seconds and try again.
If keypad does not respond after 30 seconds, then replace
battery.
Replacing the Keypad Batteries on page 8
.
TROUBLESHOOTING
