4
8. Carefully slide the main circuit board out until the ribbon cable between the camera assembly and J2 on the main circuit board is
accessible. First, disconnect the J5 connector from the main board. To remove, depress the retaining clip on the J5 connector and pull
upwards. See “2” on figure 5 below. Next, remove the ribbon cable from J2 by gently pulling up on this cable, being careful not to pull
down as damage may occur to the camera assembly. See “3” on figure 5 below.
Camera
Assembly
J2
J5
3
Grasp
here to
lift
Grasp
here to
lift
2
Figure 5
9. Carefully remove the main circuit board by sliding it free from the chassis.
